6.2.3. Oil replacement in a transmission

The design of a transmission does not provide replacement of oil during all service life of the car. However necessity of replacement of oil can sometimes arise, for example, at transition to oil with other viscosity, at transmission repair etc.

GOOD ADVICE To merge oil it is recommended during 15 mines after a trip while it has not cooled down and possesses good fluidity.

It be required to you: a key on 13, a syringe, wide capacity for merged oil.

    

THE NOTE In a transmission fill in oil API GL-4 SAE 80W-90 or SAE 75W-90. The Manufacturer recommends to replace the oil filled in at factory on трансмиссионное oil SAE 75W if the car long time maintain at air temperature more low–30 С.

1. Establish under a transmission capacity for merged oil, turn out bolts of fastening of the bottom cover of a transmission...	2. … also merge oil.

3. Uncover also a lining. Wipe a cover and a lining pure rags for removal of the rests of oil.

    

THE NOTE It is desirable to replace a lining of a bottom cover new at everyone removal.

4. Remove a protective cap from a stopper of an aperture for the pouring of oil located from above on intermediate картере of a transmission.	5. Loosen the a stopper inhaling …

6. … also turn out it.

    

THE NOTE The stopper of an aperture for oil pouring simultaneously carries out function сапуна, therefore check up cleanliness of apertures in it.

7. Turn out a stopper of a control aperture.	8. Fill in oil with a syringe in an aperture in intermediate картере …

9. … till the moment of its occurrence from a control aperture. Wrap a stopper of a control aperture.

GOOD ADVICE In a stopper the magnet for gathering of metal products of deterioration is established, clear it before stopper installation.

10. Wrap a stopper of an aperture for pouring of oil and put on it a protective cap.

THE PREVENTION Operation of the car without a protective cap of a stopper is forbidden! At its absence the road dirt will get to a transmission.