5-16-3-snyatie-proverka-i-ustanovka-ehlektromagnitnogo-klapana-sistemy-recirkulyacii-otrabotavshikh-gazov.html
5.16.3. Removal, check and installation of the electromagnetic valve of system рециркуляции the fulfilled gases1. Disconnect a wire from the plug "minus" of the storage battery.
|
|
|
|
2. Disconnect from the electromagnetic valve pad a plait of wires.
|
3. Disconnect from unions of the valve hoses of a supply and depression tap.
|
|
|
|
|
4. Wring out a clamp of fastening of the electromagnetic valve to an arm of an inlet pipe …
|
5. … also remove the valve.
|
|
THE NOTE
Pay attention to marks on the valve case that at replacement to establish the same valve.
|
6. For valve check attach to the taking away union of the valve a medical syringe (it use as the pump). Press on плунжер a syringe — in the valve pressure (it it is possible to feel on aspiration плунжера a syringe to return to a starting position) should be created. Then connect to conclusions of the valve a source of a direct current pressure 12 In — the valve should open, and pressure should disappear (плунжер a syringe without resistance will move against the stop). Otherwise replace the valve.
7. Establish the valve in an order, the return to removal.
| 