Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
5.1. Features of a design
5.2. Compression check in cylinders
5.3. Removal and installation of mudguards of the engine
5.4. Replacement of support of a suspension bracket of the power unit
5.5. Installation of the piston of the first cylinder in position ВМТ of a step of compression
5.6. Removal, installation and дефектовка a flywheel
5.7. Replacement of details of consolidation of the engine
5.8. A head of the block of cylinders
5.9. Removal and engine installation
5.10. Engine repair
5.11. Greasing system
5.12. Cooling system
5.13. System of release of the fulfilled gases
5.14. The engine power supply system
5.15. System of catching of steams of fuel
5.16. System рециркуляции the fulfilled gases
6. Transmission
7. A running gear
8. A steering
9. Brake system
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 








5-3-snyatie-i-ustanovka-bryzgovikov-dvigatelya.html

5.3. Removal and installation of mudguards of the engine

The mudguards of the engine located on each side protect подкапотное space from pollution by streams of the liquid dirt rejected during movement by forward wheels of the car, and are not power protection картера the engine. And the left mudguard is executed for a single whole with подкрылком, its removal is described in section 11 "Body" (Removal and installation of mudguards of wheels and Lockers »see«). In the given subsection removal and installation of the right mudguard, two-piece are described.

THE NOTE
By the special order the dealer full-size power protection of the engine for which in a car design fastening points are provided can be established on the car.

Remove engine mudguards at their damage or for providing of access to knots and units from below the car at repair and maintenance service carrying out.
It be required to you: a key «on 10», a screw-driver with a crosswise edge.
1. Turn out three screws of fastening of a forward part of the left mudguard …
2. … also remove a forward part of a mudguard.
3. Turn away a nut of fastening of a back part of a mudguard ahead at the left …
4. … and on the right in an arch of a forward wheel for the muffler of noise of an admission …
5. … turn out two bolts of lateral fastening …
6. … also remove a back part of the right mudguard.
7. Establish the right mudguard of the engine in an order, the return to removal.

«The previous page
5.2. Compression check in cylinders
The following page»
5.4. Replacement of support of a suspension bracket of the power unit











cf8e4909