Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
9. Brake system
9.1. Features of a design
9.2. Possible malfunctions of brake system, their reason and ways of elimination
9.3. Prorolling of a hydrodrive of brake system
9.4. Check and adjustment of position of a pedal of a brake
9.5. The main brake cylinder
9.6. The vacuum amplifier of brakes
9.7. Replacement of hoses and tubes of a hydrodrive of brakes
9.8. Removal and installation of a pedal of a brake
9.9. Brake mechanisms of forward wheels
9.9.1. Replacement brake колодок the brake mechanism of a forward wheel
9.9.2. Replacement of a support of the forward brake mechanism
9.9.3. Replacement of a brake disk
9.10. Brake mechanisms of back wheels
9.11. A lay brake
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 








9-9-3-zamena-tormoznogo-diska.html

9.9.3. Replacement of a brake disk

At presence on a working surface of a disk задиров, deep рисок and other defects increasing deterioration колодок and reducing efficiency of braking, and also in case of the raised lateral palpation of the disk causing vibrations at braking, replace a disk. In specialised workshops such disk can be pierced and прошлифовать from both parties on identical depth, but after processing the thickness of a disk should be not less is minimum admissible. Is minimum admissible thickness of a brake disk of 19 mm. If a thickness of one of disks less than the specified value, replace both disks. At replacement of brake disks necessarily replace brake колодки with the new complete set.
It be required to you: a key-shestigrannik «on 10», a key for bolts of wheels, a screw-driver with a crosswise edge.
1. Remove a wheel.
2. Remove a support in gathering («Replacement of a support of the forward brake mechanism» see), without disconnecting a brake hose, and fix a wire. Thus do not suppose twisting or a hose tension.
3. Turn out the lock screw...
4. … also remove a brake disk.
5. Similarly remove the right brake disk.
6. Establish details in an order, the return to removal.

THE NOTE
Before disk installation carefully clear привалочные surfaces of a nave and a disk of a rust and scale as even the smallest particle clamped between привалочными by surfaces, will cause palpation of a disk and vibration at braking.
    
GOOD ADVICE
If establish a former disk, remove a file fillets on working surfaces of the disk, formed as a result of deterioration of a disk from both parties.

«The previous page
9.9.2. Replacement of a support of the forward brake mechanism
The following page»
9.10. Brake mechanisms of back wheels











cf8e4909