Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
9. Brake system
9.1. Features of a design
9.2. Possible malfunctions of brake system, their reason and ways of elimination
9.3. Prorolling of a hydrodrive of brake system
9.4. Check and adjustment of position of a pedal of a brake
9.5. The main brake cylinder
9.6. The vacuum amplifier of brakes
9.7. Replacement of hoses and tubes of a hydrodrive of brakes
9.7.1. Replacement of brake hoses
9.7.2. Replacement of brake tubes
9.8. Removal and installation of a pedal of a brake
9.9. Brake mechanisms of forward wheels
9.10. Brake mechanisms of back wheels
9.11. A lay brake
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 



cf8e4909





9-7-1-zamena-tormoznykh-shlangov.html

9.7.1. Replacement of brake hoses

On the car apply four brake hoses: two (back) for connection of pipelines on a beam of a back suspension bracket and two (lobbies) for connection of pipelines with working cylinders of forward brake mechanisms.
It be required to you: keys on 10, on 12, on 19, пассатижи.

GOOD ADVICE
For отворачивания nuts of tubes apply special keys as nuts are strongly tightened and usually корродированы owing to what at using usual keys of a side of nuts are rumpled.

1. For removal of a forward hose turn away a nut of fastening of a tube, keeping the top tip of a hose from проворачивания
2. … also disconnect a tube.

GOOD ADVICE
For prevention full вытекания liquids from a hydrodrive at once muffle a tube aperture in any accessible way. For this purpose protective caps of valves for air release very well approach.

3. Remove запорную скобу from the top tip of a hose.
4. Turn out a bolt-union of fastening of the bottom tip of a hose to the working cylinder of the forward brake mechanism …

THE NOTE
Pay attention on two copper sealing washers …
… located on either side of a hose tip. At assemblage replace these washers new.

5. … also remove a brake hose.
6. Establish a new hose in an order, the return to removal.

THE PREVENTION
Track, that the hose was not overwound at installation along an axis.

7. Similarly replace the second forward hose.
8. Back brake hoses have the tips similar to the top tip of a forward hose. Replace these hoses, using the same receptions and tools, as for lobbies.
9. After replacement of hoses remove air from brake system (Prorolling of a hydrodrive of brake system see).

The previous page
9.7. Replacement of hoses and tubes of a hydrodrive of brakes
The following page
9.7.2. Replacement of brake tubes