Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
9. Brake system
9.1. Features of a design
9.2. Possible malfunctions of brake system, their reason and ways of elimination
9.3. Prorolling of a hydrodrive of brake system
9.4. Check and adjustment of position of a pedal of a brake
9.5. The main brake cylinder
9.5.1. Replacement of a tank of the main brake cylinder
9.5.2. Replacement of the main brake cylinder
9.5.3. Replacement of regulators of brake forces
9.6. The vacuum amplifier of brakes
9.7. Replacement of hoses and tubes of a hydrodrive of brakes
9.8. Removal and installation of a pedal of a brake
9.9. Brake mechanisms of forward wheels
9.10. Brake mechanisms of back wheels
9.11. A lay brake
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 



cf8e4909





9-5-3-zamena-regulyatorov-tormoznykh-sil.html

9.5.3. Replacement of regulators of brake forces

Pressure regulators replace only with the complete set (2 pieces). Marks of a regulator 3/30.
At replacement establish regulators only with the same marks.
It be required to you: keys on 10 (a special key for nuts of fastening of pipelines), on 21, on 22.
1. Turn away a nut of fastening of the pipeline, keeping a stopper of a regulator from проворачивания the second key …
2. … also take the pipeline aside.
3. Before removal of a faulty regulator (the back wheel is blocked before lobbies or simultaneously with them) check up cleanliness of its working chamber. For this purpose ослабьте an inhaling of a stopper of a regulator, keeping a regulator from проворачивания the second key...
4. … also turn out a stopper together with a spring and плунжером. Clear details of a regulator of pollution, wash out their fresh brake liquid and establish into place. Remove air from system (Prorolling of a hydrodrive of brake system see, with. 187) and again check up a regulator overall performance.
5. If working capacity of a regulator was not restored, replace both regulators with the complete set. Having disconnected from a regulator the pipeline (subitem 1 and 2 see), ослабьте an inhaling of a regulator of pressure...
6. … also turn out a regulator from the case of the main brake cylinder.

    
THE PREVENTION
Sealing ring of a regulator of pressure at each dismantling of connection replace new.

7. Similarly remove the second regulator of pressure.
8. Establish pressure regulators in an order, the return to removal, and remove air from a hydrodrive of brake system (Prorolling of a hydrodrive of brake system see).

The previous page
9.5.2. Replacement of the main brake cylinder
The following page
9.6. The vacuum amplifier of brakes