Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
9. Brake system
9.1. Features of a design
9.2. Possible malfunctions of brake system, their reason and ways of elimination
9.3. Prorolling of a hydrodrive of brake system
9.4. Check and adjustment of position of a pedal of a brake
9.5. The main brake cylinder
9.5.1. Replacement of a tank of the main brake cylinder
9.5.2. Replacement of the main brake cylinder
9.5.3. Replacement of regulators of brake forces
9.6. The vacuum amplifier of brakes
9.7. Replacement of hoses and tubes of a hydrodrive of brakes
9.8. Removal and installation of a pedal of a brake
9.9. Brake mechanisms of forward wheels
9.10. Brake mechanisms of back wheels
9.11. A lay brake
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 








9-5-1-zamena-bachka-glavnogo-tormoznogo-cilindra.html

9.5.1. Replacement of a tank of the main brake cylinder

The screw-driver is required to you.
1. Disconnect a wire from the plug "minus" of the storage battery.
2. Having unclenched clamps, disconnect pad a plait of wires from a stopper of a tank of the main brake cylinder.
3. Turn away a stopper of a tank of the main brake cylinder.
4. Pump out a brake liquid from a tank, for example, the big medical syringe.
5. Loosen the a collar of fastening of a hose to the main cylinder of deenergizing of coupling, shift a collar on a hose …
6. … also disconnect a hose from a tank of the main brake cylinder.

    
GOOD ADVICE
At once after a detachment of a hose from a tank muffle its aperture, without lowering a hose downwards. Thus in a hose there will be a quantity of a working liquid, therefore after installation of a tank and joining to it of a hose to delete air from a hydrodrive of deenergizing of coupling it is not required.

7. Having hooked a screw-driver, remove a tank, taking its branch pipes from connecting plugs.
8. If leak of a brake liquid through connecting plugs was while in service observed, take plugs from apertures of the case of the cylinder.
    
THE PREVENTION
The reuse of connecting plugs is not supposed, replace their new.

9. Before tank installation insert into apertures of the main brake cylinder connecting plugs. Then establish a tank, having inserted its branch pipes into connecting plugs effort of a hand against the stop.

GOOD ADVICE
For simplification of installation of connecting plugs in the cylinder and tank branch pipes in plugs moisten with their fresh brake liquid.

10. Fill in a brake liquid and remove air from a hydrodrive («Prorolling of a hydrodrive of brake system» see).

«The previous page
9.5. The main brake cylinder
The following page»
9.5.2. Replacement of the main brake cylinder











cf8e4909