Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
9. Brake system
10. An electric equipment
11. A body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal, dismantling and installation of bumpers
11.4. Removal and installation of facing of a radiator
11.5. Removal and installation of mudguards of wheels and Lockers
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice of a box air flow
11.8. A cowl
11.9. Doors
11.10. A luggage carrier cover
11.11. A cover of the hatch of a bulk pipe of a fuel tank
11.12. Seats
11.13. Removal and installation of facing of a tunnel of a floor
11.14. System of passive safety (SRS)
11.14.1. Features of a design
11.14.2. Removal and installation of a pillow of safety of the driver
11.14.3. Replacement of a forward seat belt
11.14.4. Replacement of a back seat belt
11.14.5. Removal and installation of the electronic block of management by additional system of passive safety
11.15. Rear-view mirrors
11.16. The panel of devices
11.17. A heater and the conditioner
11.18. Salon armature
11.19. Removal and installation of facings of salon
11.20. Removal and installation of facings of a luggage carrier
11.21. A screen wiper of a wind window
11.22. Replacement motionless glazing bodies
11.23. Removal and installation of a shelf of fastening of the storage battery
11.24. Care of a body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 



cf8e4909





11-14-5-snyatie-i-ustanovka-ehlektronnogo-bloka-upravleniya-dopolnitelnojj-sistemojj-passivnojj-bezopasnosti.html

11.14.5. Removal and installation of the electronic block of management by additional system of passive safety

It be required to you: all tools necessary for removal of facing of a tunnel of a floor, and key TORX T30.
1. Disconnect a wire from the plug "minus" of the storage battery.
2. Remove facing of a tunnel of a floor (Removal and installation of facing of a tunnel of a floor see).
3. Cast away a clamp колодки a plait of wires of the electronic block of management …
4. … also disconnect pad from the block.
5. Turn out three bolts of fastening of the block of management to the body basis …
6. … also remove the block.

THE NOTE
Pay attention to marks of the block of management, for replacement get the block with the same marks.

7. Establish the electronic block of management of system of passive safety and all removed details in an order, the return to removal. The arrow on the block case should specify forward.

The previous page
11.14.4. Replacement of a back seat belt
The following page
11.15. Rear-view mirrors