Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
9. Brake system
10. An electric equipment
11. A body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal, dismantling and installation of bumpers
11.4. Removal and installation of facing of a radiator
11.5. Removal and installation of mudguards of wheels and Lockers
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice of a box air flow
11.8. A cowl
11.9. Doors
11.10. A luggage carrier cover
11.11. A cover of the hatch of a bulk pipe of a fuel tank
11.12. Seats
11.13. Removal and installation of facing of a tunnel of a floor
11.14. System of passive safety (SRS)
11.15. Rear-view mirrors
11.16. The panel of devices
11.17. A heater and the conditioner
11.18. Salon armature
11.19. Removal and installation of facings of salon
11.20. Removal and installation of facings of a luggage carrier
11.21. A screen wiper of a wind window
11.22. Replacement motionless glazing bodies
11.23. Removal and installation of a shelf of fastening of the storage battery
11.24. Care of a body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 








11-13-snyatie-i-ustanovka-oblicovki-tonnelya-pola.html

11.13. Removal and installation of facing of a tunnel of a floor

Facing of a tunnel of a floor consists of two parts: forward and back.
The screw-driver with a crosswise edge is required to you.
1. Turn out two screws behind a back part of facing at the left …
2. … and on the right.

THE NOTE
The seat of the driver is removed for descriptive reasons. For access reception to facing fastenings to remove a seat it is not required.

3. Lift upwards the lever of a lay brake, shift an a bit back part of facing back, deducing its clamps from gearing with a forward part …
4. … also remove it, having moved upwards and forward on the lever of a lay brake.

    
THE NOTE
For removal of a forward part of facing of a tunnel of a floor it is unessential to remove a back part, it is enough to turn out screws of its fastening and to shift a little back.

5. Take from a forward part of facing of a tunnel of a floor a framework of a cover of a control lever a transmission, overcoming effort of its clamps.
6. Through a window for installation of a cover of a control lever by a transmission separate pad a plait of wires cigarette Lighter.
7. Turn out one screw of fastening behind a forward part of facing …
8. … and two screws ahead.

    
THE NOTE
The second screw of fastening of a forward part of facing of a tunnel of a floor is symmetrized concerning a longitudinal axis of the car.

9. Develop a framework of a cover of a control lever a transmission so that it has passed in an aperture of a forward part of facing of a tunnel of a floor, and remove a forward part of facing.
10. Establish parts of facing of a tunnel of a floor in an order, the return to removal.

«The previous page
11.12.3. Removal and installation of a back seat
The following page»
11.14. System of passive safety (SRS)











cf8e4909