10.8.11. Check and replacement подрулевых switches

It be required to you: screw-drivers with flat and crosswise edges.

1. Disconnect a wire from the plug "minus" of the storage battery.

2. Remove a steering wheel (Removal and steering wheel installation see).	3. Remove a casing of a steering column (Replacement of contact group of the switch (the lock) ignitions see).

4. Compress clamps and take the switch of indexes of turn and light of headlights from a connector.	5. Compress a clamp and disconnect from the switch pad a plait of wires.

6. Compress a clamp and separate additional pad.	7. Compress clamps, take the switch of a cleaner and a washer of a windscreen from a connector …

8. … also disconnect from it pad a plait of wires, having compressed its clamp.

9. Establish details in an order, the return to removal.

Removal подрулевых switches in gathering with a connector carry out in a following order.

1. Disconnect a wire from the plug "minus" of the storage battery.

2. Remove a steering wheel (Removal and steering wheel installation see).	3. Remove casings of a steering column (Replacement of contact group of the switch (the lock) ignitions see).

4. Turn out four screws of fastening …	5. … also remove the bottom facing of the panel of devices.

6. Compress clamps and separate big …	7. … and small колодки a plait of wires of a contact ring of a pillow of safety.

8. Disconnect the holder of a collar of a plait of wires of a contact ring from an arm on a steering column.	9. Turn out four screws of fastening …

10. … also remove a contact ring of a pillow of safety.	11. Turn out two screws of fastening of a connector to a steering column.

12. Disconnect from подрулевых switches колодки a plait of wires and separate additional pad the switch of indexes of turn and light of headlights.

13. Remove from a steering column a connector and disconnect from it a wire.

14. Establish details in an order, the return to removal.

Serviceability подрулевых switches define, checking correctness of short circuit of contacts at various positions of levers. Remove switches for check and connect a control lamp on 12 In (with a current source) or an autotester with function chain "procalls" to the corresponding conclusions specified in tab. 10.7 and 10.8. Translate the switch lever in the position corresponding to checked contacts, – the lamp should light up. Otherwise the switch is faulty.