Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
9. Brake system
9.1. Features of a design
9.2. Possible malfunctions of brake system, their reason and ways of elimination
9.3. Prorolling of a hydrodrive of brake system
9.4. Check and adjustment of position of a pedal of a brake
9.5. The main brake cylinder
9.6. The vacuum amplifier of brakes
9.7. Replacement of hoses and tubes of a hydrodrive of brakes
9.8. Removal and installation of a pedal of a brake
9.9. Brake mechanisms of forward wheels
9.10. Brake mechanisms of back wheels
9.10.1. Removal and installation of a brake drum
9.10.2. Replacement brake колодок the brake mechanism of a back wheel
9.10.3. Replacement of the working cylinder of the brake mechanism of a back wheel
9.11. A lay brake
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 



cf8e4909





9-10-3-zamena-rabochego-cilindra-tormoznogo-mekhanizma-zadnego-kolesa.html

9.10.3. Replacement of the working cylinder of the brake mechanism of a back wheel

If have while in service appeared begin to flow a brake liquid on a brake drum and an inside of a wheel or has jammed pistons in the cylinder, replace the working cylinder.
It be required to you: keys on 9, on 10, a special key on 10 for nuts of pipelines, a key for bolts of wheels.
1. Include I transfer and establish an emphasis under forward wheels.
2. Remove a corresponding back wheel.
3. Clear of a dirt a place of fastening of a brake tube and bolts of fastening of the working cylinder from an underside of a brake board.
4. Remove a brake drum (Removal and installation of a brake drum see).
5. Lift the lever of a lay brake — the top ends колодок will depart from an emphasis of pistons.
6. Remove a protective cap and turn out the valve for air removal.
7. Turn away a nut of fastening of a brake tube to the working cylinder and muffle a tube aperture, for example, a cap of the valve of release of air.

GOOD ADVICE
After long operation the nut of a brake tube "grows together" with a tube in a single whole, therefore at attempt to turn away a nut the tube is braided and breaks. In this case only shift a tube nut a little, then turn out a bolt of fastening of the cylinder and disconnect it from a tube, screwing together the cylinder from its nut. After a detachment of the cylinder from a tube mobility of the released nut can be restored, having moistened with its brake liquid and turning a nut a key alternately in both parties.

8. Turn out a bolt of fastening of the working cylinder, holding the cylinder on the other hand …
9. … also remove the working cylinder.
10. If on the valve of release of air of the new cylinder there is no protective cap, remove it from the old valve.
11. Establish the working cylinder in an order, the return to removal.
12. Establish a brake drum (Removal and installation of a brake drum see).
13. Adjust bearings of a back nave (Adjustment of bearings of a back nave see).
14. Remove air from brake system (Prorolling of a hydrodrive of brake system see).
15. Some times sharply press a brake pedal to bring brake колодки to a drum.

The previous page
9.10.2. Replacement brake колодок the brake mechanism of a back wheel
The following page
9.11. A lay brake