Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
7.1. A forward suspension bracket
7.1.1. Features of a design
7.1.2. Possible malfunctions of a forward suspension bracket, their reason and ways of elimination
7.1.3. Removal and installation absorber racks
7.1.4. Repair absorber racks
7.1.5. Replacement of the top support absorber racks
7.1.6. Replacement of a spherical support absorber racks
7.1.7. Replacement of the lever of a forward suspension bracket
7.1.8. Replacement of details of the stabilizer of cross-section stability of a forward suspension bracket
7.1.9. Replacement of the bearing of a forward nave
7.2. A back suspension bracket
8. A steering
9. Brake system
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 








7-1-7-zamena-rychaga-perednejj-podveski.html

7.1.7. Replacement of the lever of a forward suspension bracket

It be required to you: keys «on 12», «on 14», «on 17», «on 19», «on 22», a face head «on 12», круглогубцы, a stripper of spherical hinges.
1. Brake the car a lay brake and establish противооткатные an emphasis ("boots") under back wheels. Raise a jack a forward part of the car and establish it on support. Remove a wheel.
    
THE PREVENTION
Weaken and tighten bolts of fastening of a wheel only on the car standing on the earth.

2. Remove a spring clamp, turn away a nut of fastening of a finger of a spherical support and выпрессуйте a finger (Replacement of a spherical support absorber racks »see«).
3. Turn away a nut of fastening of a rack of the stabilizer to a bar and remove a rack («Replacement of details of the stabilizer of cross-section stability of a forward suspension bracket» see).
4. Turn out two bolts of fastening скобы a back support of the lever …
5. … also remove скобу.
6. Turn away a nut of fastening of a bolt of a forward support of the lever...
7. … remove a washer, take out a bolt together with the second washer...
    
GOOD ADVICE
If the bolt is not taken out, beat out it from a body arm, putting blows by a back part of the lever.

8. … also remove the lever in gathering with a spherical support.
    
THE NOTE
As original bottom levers of a forward suspension bracket deliver in spare parts in gathering with a spherical support, сайлентблоком and the plug of a back support, the further dismantling of the lever is not meaningful. It is possible to remove only the plug of a back support delivered separately in spare parts which is easy for bringing down from an axis hammer blows.

9. Establish details in an order, the return to removal, without tightening definitively fastening резинометаллических hinges of the lever and the stabilizer of cross-section stability.
10. Having lowered the car on the earth, some times strongly rock it. Definitively tighten carving connections of a suspension bracket on the car standing on the earth, the moment specified in the appendix 1.

THE NOTE
After replacement of a spherical support of a forward suspension bracket check up and if necessary adjust corners of installation of wheels. Take advantage of services of the workshops having the special equipment.

«The previous page
7.1.6. Replacement of a spherical support absorber racks
The following page»
7.1.8. Replacement of details of the stabilizer of cross-section stability of a forward suspension bracket











cf8e4909