Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
7.1. A forward suspension bracket
7.1.1. Features of a design
7.1.2. Possible malfunctions of a forward suspension bracket, their reason and ways of elimination
7.1.3. Removal and installation absorber racks
7.1.4. Repair absorber racks
7.1.5. Replacement of the top support absorber racks
7.1.6. Replacement of a spherical support absorber racks
7.1.7. Replacement of the lever of a forward suspension bracket
7.1.8. Replacement of details of the stabilizer of cross-section stability of a forward suspension bracket
7.1.9. Replacement of the bearing of a forward nave
7.2. A back suspension bracket
8. A steering
9. Brake system
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 








7-1-6-zamena-sharovojj-opory-amortizatornojj-stojjki.html

7.1.6. Replacement of a spherical support absorber racks

If support check has confirmed necessity of its replacement (Check of a technical condition of a forward suspension bracket see the car »«), replace it.
It be required to you: keys «on 17» (two), «on 19», a key for bolts of wheels, a stripper of spherical hinges, a drill, a drill on metal in diameter of 12 mm.
1. Lift and establish a forward part of the car on support. Remove a wheel.

    
PREVENTIONS
Brake the car a lay brake and establish under back wheels противооткатные an emphasis ("boots").
Weaken and tighten bolts of fastening of a wheel only on the car standing on the earth.

2. Remove a spring clamp of a nut of a finger of a spherical support.
3. Turn away a nut of fastening of a finger of a spherical support to the suspension bracket lever...
4. … establish a stripper of spherical hinges and выпрессуйте a finger from the lever.
5. If the spherical support is attached to the lever by rivets (factory installation), drill three rivets.
    
GOOD ADVICE
To drill rivets it is more convenient on the removed lever of a forward suspension bracket («Replacement of the lever of a forward suspension bracket» see).

6. If the support is attached by bolts (it already changed), turn away three self-locking nuts, keeping bolts from проворачивания the second key.
    
THE PREVENTION
Самоконтрящиеся nuts are not subject to a reuse, replace their new.

7. Take rivets (bolts) from apertures of a spherical support and the lever, then remove a support.
8. Establish a spherical support in an order, the return to removal.
    
THE PREVENTION
At installation do not damage a protective cover of a spherical support.

9. Having lowered the car on the earth, some times strongly rock it. Tighten a nut of fastening of a finger of a spherical support and bolts of fastening of a support to the lever the moment 70 Н·м, establish a spring clamp of a nut of a finger of a support.

THE NOTE
After replacement of a spherical support of a forward suspension bracket check up and if necessary adjust corners of installation of wheels. Take advantage of services of the workshops having the special equipment.

«The previous page
7.1.5. Replacement of the top support absorber racks
The following page»
7.1.7. Replacement of the lever of a forward suspension bracket











cf8e4909