4-2-4-proverka-urovnya-i-dolivka-tormoznojj-zhidkosti-v-bachok.html
4.2.4. Check of level and доливка a brake liquid in a tank of a hydrodrive of brake systemIt be required to you: a brake liquid, a pure rag.
|
GOOD ADVICE
Type of a brake liquid — DOT-3 or DOT-4.
We recommend to check level before each departure and if necessary to add a liquid in a tank. If to add a brake liquid in a tank it is necessary often enough, at once eliminate malfunction (section 9 Brake system see).
At replacement of a brake liquid in system remember or write down mark of a liquid which will be filled in that at доливке to use the same mark.
|
The tank is established on the main cylinder of a brake on the left side of a motor compartment at a board передка.
|
THE PREVENTION
Observe safety measures at work with a brake liquid: it is toxic.
|
|
GOOD ADVICE
That in the future not to subject itself to contingencies on repair of brake system, and even all car as a whole, in due time replace a brake liquid fresh. It very much гигроскопична also absorbs a moisture from air that, besides occurrence of corrosion of details of brake system, lowers temperature of boiling of the liquid, and it can lead to refusal of brakes at frequent intensive braking.
Do not use the liquid merged from system repeatedly: it is polluted, sated by air and a moisture.
Hit of a brake liquid on wires, the plastic or painted details of a body can cause their damage, therefore at pouring always enclose pure rags. At liquid hit on these details at once wipe their pure rag.
|
|
|
|
|
1. Check up level of a brake liquid in a tank. It should be between labels MIN and MAX, put on the tank case.
|
2. If level of a liquid below a label MIN, turn away a tank stopper …
|
|
THE PREVENTION
Gradual fall of level of a brake liquid in the absence of leaks specifies, most likely, in necessity of replacement brake колодок. Check up a condition brake колодок (Check of degree of deterioration brake колодок, disks and drums see). Untimely replacement колодок leads to expensive repair (replacement of brake disks, drums, supports)!
|
|
|
|
|
3. … also add a brake liquid to a label MAX.
|
4. Then wrap the tank stopper, the spilt liquid wipe a pure rag.
|
|
|
