Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
9. Brake system
10. An electric equipment
11. A body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal, dismantling and installation of bumpers
11.4. Removal and installation of facing of a radiator
11.5. Removal and installation of mudguards of wheels and Lockers
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice of a box air flow
11.8. A cowl
11.9. Doors
11.10. A luggage carrier cover
11.11. A cover of the hatch of a bulk pipe of a fuel tank
11.12. Seats
11.13. Removal and installation of facing of a tunnel of a floor
11.14. System of passive safety (SRS)
11.15. Rear-view mirrors
11.16. The panel of devices
11.17. A heater and the conditioner
11.17.1. Features of the device
11.17.2. Removal and installation of the block of management by heating and air-conditioning system
11.18. Salon armature
11.19. Removal and installation of facings of salon
11.20. Removal and installation of facings of a luggage carrier
11.21. A screen wiper of a wind window
11.22. Replacement motionless glazing bodies
11.23. Removal and installation of a shelf of fastening of the storage battery
11.24. Care of a body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 



cf8e4909





11-17-2-snyatie-i-ustanovka-bloka-upravleniya-sistemojj-otopleniya-i-kondicionirovaniya.html

11.17.2. Removal and installation of the block of management by heating and air-conditioning system

It be required to you: screw-drivers with flat and crosswise edges.
1. Disconnect a wire from the plug "minus" of the storage battery.
2. Having wrung out a screw-driver spring clamps from both parties of a facing overlay of the console of the panel of devices above …
3. … and below, remove an overlay.
4. Turn out two screws of fastening заглушки boxing for radio tape recorder installation …
5. … take away заглушку from the panel of devices, disconnect from заглушки pad a plait of wires, take out from the holder a cable of the aerial and remove заглушку.
6. Take from a nest of the panel of devices boxing for radio tape recorder installation.
7. Turn out two screws of fastening to the panel of devices of the block of management of heating and air-conditioning system …
8. … deduce three clamps in the top part of the block from gearing with the panel of devices and move the block on itself so, the length of wires and draughts how much allows.
9. Disconnect from the block колодки a plait of wires.
10. Having wrung out a finger a clamp of a cover of draught of management заслонкой distributions of streams of air …
11. … disconnect a cover from the case of a heater and remove draught from a lever finger заслонки.
12. Similarly disconnect from levers of a heater draught of management заслонками regulations of temperature of air arriving in salon …
13. … and заслонкой рециркуляции.
14. Remove the block of management of heating and air-conditioning system together with draughts. If necessary disconnect from levers of the block of draught the same as it did at their detachment from heater levers (subitem 11-14 see).
15. Establish the block of management of heating and air-conditioning and all removed details in an order, the return to removal.

The previous page
11.17.1. Features of the device
The following page
11.18. Salon armature