Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
8.1. Features of a design
8.2. A steering column
8.3. Steering draughts
8.3.1. Replacement of an external tip of steering draught
8.3.2. Replacement of steering draught
8.4. The steering mechanism
9. Brake system
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 



cf8e4909





8-3-2-zamena-rulevojj-tyagi.html

8.3.2. Replacement of steering draught

It be required to you: keys on 12, on 15, on 17, on 19, a key for bolts of wheels, a screw-driver with a flat edge, a stripper of spherical hinges, a calliper.

NOTES
Work is more convenient for carrying out on the lift. It is possible to spend it and on the car established on support.
Replacement is shown on an example of the left steering draught, the right draught replace similarly.

1. Lift and establish on a support a forward part of the car of from outside replaced draught. Remove a wheel.
    
THE PREVENTION
Brake the car a lay brake and establish under back wheels противооткатные an emphasis ("boots").

GOOD ADVICE
If fixing details are strongly polluted, clear their metal brush and process легкопроникающей greasing, for example WD-40.

2. Having hooked a screw-driver, remove a lock plate of bolts of fastening of steering bent for рейке the steering mechanism.
3. Turn out a bolt of fastening of bent for рейке
4. … also take a bolt from apertures of a directing lath рейки, steering draught and a basic plate.
5. Take away draught from a basic plate and remove a washer.
6. Turn away a nut of fastening of a finger of the spherical hinge of a tip, establish a stripper of spherical hinges and выпрессуйте a finger of a tip of steering draught (Replacement of an external tip of steering draught see).
7. Remove from the car steering draught in gathering.
8. Measure free length of an adjusting bolt.
9. Loosen the an inhaling of bolts клеммовых connections …
10. … also turn out an adjusting bolt from draught and a tip.

THE NOTE
At carving parts of a bolt the different direction of a carving, therefore a bolt at rotation will be turned out simultaneously from draught and a tip.

11. Clear and examine details of steering draught, faulty details replace.
12. Establish details in an order, the return to removal. At assemblage consider the following requirement: the adjusting bolt should be screwed in draught and a tip on identical number of turns. Whenever possible to keep adjustment of a convergence of wheels, at draught assemblage be guided on measured (item 8 see) free length of an adjusting bolt. The moment of an inhaling of a bolt клеммового connections 22 Нм, nuts of a finger of the spherical hinge 60 Нм, a bolt of fastening of bent for рейке the steering mechanism 90 Нм.
13. Check up and if necessary adjust corners of installation of forward wheels (Check and adjustment of corners of installation of wheels see).

The previous page
8.3.1. Replacement of an external tip of steering draught
The following page
8.4. The steering mechanism