Chevrolet Lanos (since 2004 of release)
	1. The car device
	2. Recommendations about operation
	3. Malfunctions in a way
	4. Maintenance service
	5. The engine
	6. Transmission
	7. A running gear
	8. A steering
	9. Brake system
		9.1. Features of a design
		9.2. Possible malfunctions of brake system, their reason and ways of elimination
		9.3. Prorolling of a hydrodrive of brake system
		9.4. Check and adjustment of position of a pedal of a brake
		9.5. The main brake cylinder
		9.6. The vacuum amplifier of brakes
		9.7. Replacement of hoses and tubes of a hydrodrive of brakes
		9.8. Removal and installation of a pedal of a brake
		9.9. Brake mechanisms of forward wheels
		9.10. Brake mechanisms of back wheels
		9.11. A lay brake
			9.11.1. Adjustment of a drive of a lay brake
			9.11.2. Replacement of a forward cable of a drive of a lay brake
			9.11.3. Replacement of a back cable of a drive of a lay brake
			9.11.4. Removal and installation of the lever of a drive of a lay brake
	10. An electric equipment
	11. A body
	12. Wheels and tyres
	13. Purchase of spare parts
	14. A trip on HUNDRED
	15. Winter operation of the car
	16. Preparation for checkup
	17. Councils to the beginning mechanic
	18. Appendices
	19. Electric equipment schemes

9-11-4-snyatie-i-ustanovka-rychaga-privoda-stoyanochnogo-tormoza.html

9.11.4. Removal and installation of the lever of a drive of a lay brake

The lever in gathering remove for replacement at deterioration or damage of gear sector or the doggie.

It be required to you: a key on 12, a screw-driver with a crosswise edge.

1. Disconnect a wire from the plug "minus" of the storage battery.

2. Remove a back part of facing of a tunnel of a floor (Removal and installation of facing of a tunnel of a floor see).

THE NOTE

The seat of the driver is removed for descriptive reasons. To get access to fastenings of facing and the lever of a lay brake, to remove a seat it is not required.


3. Disconnect pad wires from the switch of an alarm lamp of inclusion of a lay brake.	4. Disconnect from the lever of a drive of a lay brake a forward cable of a drive (Replacement of a forward cable of a drive of a lay brake see).


5. Turn out two bolts of fastening of the lever of a drive of a lay brake to the body basis …	6. … also remove the lever.

7. Before installation on the car grease консистентной with greasing gear sector of the lever.

8. Establish the lever in an order, the return to removal, and adjust lay brake system (Adjustment of a drive of a lay brake see).

The previous page
9.11.3. Replacement of a back cable of a drive of a lay brake

The following page
10. An electric equipment