9.11.2. Replacement of a forward cable of a drive of a lay brake

Forward cable of a drive of a lay brake replace at its excessive вытягивании (impossibility of adjustment of a lay brake), mechanical damages of veins of a cable or a carving tip.

It be required to you: a key on 10, screw-drivers with flat and crosswise edges, пассатижи.

1. Remove a back part of facing of a tunnel of a floor (Removal and installation of facing of a tunnel of a floor see).

THE NOTE The seat of the driver is removed for descriptive reasons. To get access to fastenings of facing and to adjusting knot of a drive of a lay brake, to remove a seat it is not required.

2. Lower the lever of a lay brake down to an emphasis, completely turn on and remove from a carving tip of a forward cable an adjusting nut.	3. Take a tip of a cable from directing the lever of a drive of a lay brake.

4. A screw-driver unbend two clamps of a cover of a cable …	5. … also disconnect a forward cable from the lever.

6. From below the car remove from arms on a body of a pillow of a suspension bracket of the additional muffler and take away downwards system of release of the fulfilled gases, how much it allows elasticity of other pillows of a suspension bracket.	7. Remove the thermoscreen of the additional muffler (Removal and installation of thermoscreens see).

8. Disconnect from the equalizer tips of back cables of a drive, having deduced them from equalizer cuts.	9. Take from an aperture of the basis of a body a cover of a forward cable and remove a cable from the car, having extended a cable downwards through an aperture in the body basis.

10. Establish a forward cable of a drive of a lay brake and all removed details in an order, the return to removal.

11. Adjust lay brake system (Adjustment of a drive of a lay brake see).