9.11.3. Replacement of a back cable of a drive of a lay brake

Back cable of a drive of a lay brake replace at its excessive вытягивании (impossibility of adjustment of a lay brake), mechanical damages of veins of a cable or its cover.

    

THE NOTE Each brake mechanism of back wheels is resulted by a separate cable. Removal and installation of the left cable are shown. The right cable remove and establish similarly.

It be required to you: a key and a face head on 10, a screw-driver with a flat edge, пассатижи.

1. Loosen the a tension of cables of a drive, having turned away an adjusting nut to the end of a carving tip of a forward cable (subitem 1 and 2 Replacement of a forward cable of a drive of a lay brake see), but without removing a nut absolutely.

2. Disconnect from the equalizer a tip of a back cable of a drive, having deduced it from an equalizer cut.	3. Having turned away a fastening nut, remove supporting arm of a cable on a guard of a fuel tank …

4. … then forward …	5. … and back holders on a body …

6. … and also the holder on the lever of a back suspension bracket.	7. Having hooked a screw-driver, take the adjusting plug of a cover of a cable from an arm on the basis of a body …

8. … also take out a cable from an arm aperture.

9. Remove a brake drum (Removal and installation of a brake drum see).

10. Wring out a screw-driver forward разжимной the lever …	11. … and пассатижами disconnect from разжимного the lever a cable tip.

12. From an underside of a board of a brake remove a spring clamp of a cover of a cable …	13. … and, having extended a cable through an aperture in a board, remove it from the car.

14. Establish a back cable of a drive of a lay brake in an order, the return to removal.

15. Adjust lay brake system (Adjustment of a drive of a lay brake see).