Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
9. Brake system
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
17.1. Safety precautions at carrying out of repair work
17.1.1. The general requirements
17.1.2. Safe lifting of the car
17.2. Tools
17.3. Before the work beginning
17.4. Restoration of carving connections
18. Appendices
19. Electric equipment schemes
 








17-1-2-bezopasnyjj-podem-avtomobilya.html

17.1.2. Safe lifting of the car

For safe lifting of the car by a jack it is necessary to execute the following.
1. Establish the car on an equal firm surface.
2. Before lifting release the car from extraneous subjects. In advance get from a luggage carrier all necessary for repair (spare parts, tools) as access to the lifted car can be complicated or impossible.
3. Establish a jack only under those places which are for this purpose intended. Power elements of a body in these parts specially утолщены also have the raised durability.
4. Enclose противооткатные an emphasis under car wheels from outside, the opposite lifted.
5. For prevention проседания and jack cave-in in the earth enclose under it a board (20х20х2 sm).
6. Bring a persistent head to a car body, thus the jack should be established perpendicularly basic surface.
7. Before to lift the car a jack on the demanded height, once again attentively check up, whether it has tilted in any party.
8. Support establish too only under specially intended for lifting of the car of a place. Between a support and a car body enclose a rubber or wooden lining.
9. Establish a three-legged support so that two her feet were from outside car bodies, and one – outside.
At use for lifting of the car of the lift observe the following safety requirements.
1. During lifting and car lowering it is forbidden to be near to it in order to avoid accident.
2. If there was a danger of falling of the car, immediately leave a dangerous zone.
3. Correctly have on the lift the car centre of gravity to avoid its falling.
4. Protect feet not to press their paws of the lift or car wheels at lowering.
5. Do not make excessive effort controls the lift.
6. To operate the lift the qualified personnel should only.
7. Do not suppose excessive rocking of the car on the lift.
8. Lift paws establish only under those places which are for this purpose intended. Power elements of a body in these parts specially утолщены also have the raised durability.
9. At removal of heavy knots and units from the car which is on the lift, establish additional support.

«The previous page
17.1.1. The general requirements
The following page»
17.2. Tools











cf8e4909