Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
8.1. Features of a design
8.2. A steering column
8.3. Steering draughts
8.3.1. Replacement of an external tip of steering draught
8.3.2. Replacement of steering draught
8.4. The steering mechanism
9. Brake system
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 



cf8e4909





8-3-1-zamena-naruzhnogo-nakonechnika-rulevojj-tyagi.html

8.3.1. Replacement of an external tip of steering draught

It be required to you: keys on 12, on 17, on 19, a key for bolts of wheels, a stripper of spherical hinges.

NOTES
Work is more convenient for carrying out on the lift. It is possible to execute it and on the car established on support.
Tip replacement is shown on an example of the left steering draught, the right tip replace similarly.
Carving of the left tip right, and right — left.

1. Lift and establish on a support a forward part of the car of from outside replaced tip. Remove a wheel.

THE PREVENTION
Brake the car a lay brake and establish under back wheels противооткатные an emphasis ("boots").

GOOD ADVICE
If fixing details are strongly polluted, clear their metal brush and process легкопроникающей greasing, for example WD-40.

2. Turn away a nut of fastening of a spherical finger of a tip to the rotary lever of a telescopic rack.

THE NOTE
Nuts of fastening of spherical fingers of external tips of steering draughts self-locking. At each removal replace nuts new.

3. Establish a stripper of spherical hinges and выпрессуйте a finger from a lug of the rotary lever.

GOOD ADVICE
In the absence of a stripper the finger of the spherical hinge can be beaten out sharp blows of a hammer on an end face of a lug of the rotary lever, putting blows along a lever axis.

4. Loosen the a bolt inhaling клеммового connections of a tip of steering draught.
5. Screw together a tip from steering draught, counting up quantity of turns that at installation of a new tip the convergence of wheels whenever possible has not changed. If necessary keep a key draught from проворачивания for sides of an adjusting bolt (are shown by an arrow).
6. Establish a new tip in an order, the return to removal, having screwed it on steering draught on so much turns, how many it has been counted up at removal. The moment of an inhaling of a bolt клеммового connections 22 Нм, nuts of a finger of the spherical hinge 60 Нм.
7. Check up and in case of need adjust corners of installation of wheels at servicing deport.

The previous page
8.3. Steering draughts
The following page
8.3.2. Replacement of steering draught