Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
6.1. Coupling
6.2. A transmission
6.2.1. Features of a design
6.2.2. Possible malfunctions of a transmission, their reason and ways of elimination
6.2.3. Oil replacement in a transmission
6.2.4. Replacement of epiploons of a transmission
6.2.5. Removal and transmission installation
6.2.6. Dismantling and assemblage of a transmission and дефектовка its details
6.2.7. Repair of a secondary shaft
6.2.8. Repair of a primary shaft
6.2.9. Synchronizer repair
6.2.10. Differential repair
6.2.11. Repair of the mechanism of a gear change
6.2.12. Repair of hinges of a drive of a gear change
6.2.13. Removal, installation and repair of a side scene of a control lever by a transmission
6.2.14. Adjustment of a drive of management by a transmission
6.3. Drives of forward wheels
7. A running gear
8. A steering
9. Brake system
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes



6.2.8. Repair of a primary shaft

It be required to you: a stripper for lock rings, a universal stripper.
1. Press from a neck the back bearing of a primary shaft …
2. … also remove the bearing from a shaft.
3. Unclench a lock ring of the block of gear wheels …
4. … also remove a ring from a shaft.
5. Press the block of gear wheels from necks …
6. … also remove it from a shaft.
7. Examine a primary shaft and the block of gear wheels. Working surfaces of teeths of gear wheels should not have having chopped off, wear tracks and выкрашивания, end faces шлицев gear wheels — having chopped off, выкрашиваний and замятия. The bearing greased трансмиссионным with oil, should rotate easily, without noise, knock and jamming. Surfaces of bodies качения should not have traces of fatigue failures. The bearing separator should not have damages. At replacement of a primary shaft check up ease of its moving in a nave of a conducted disk of coupling.
8. Collect a primary shaft in an order, the return to dismantling. The back bearing напрессовывайте on a shaft, putting effort only to an internal ring, differently the bearing will be damaged.

The previous page
6.2.7. Repair of a secondary shaft
The following page
6.2.9. Synchronizer repair