Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
5.1. Features of a design
5.2. Compression check in cylinders
5.3. Removal and installation of mudguards of the engine
5.4. Replacement of support of a suspension bracket of the power unit
5.5. Installation of the piston of the first cylinder in position ВМТ of a step of compression
5.6. Removal, installation and дефектовка a flywheel
5.7. Replacement of details of consolidation of the engine
5.8. A head of the block of cylinders
5.9. Removal and engine installation
5.10. Engine repair
5.11. Greasing system
5.12. Cooling system
5.13. System of release of the fulfilled gases
5.14. The engine power supply system
5.15. System of catching of steams of fuel
5.15.1. Features of the device
5.15.2. Removal, installation and check of the valve of a purge of an adsorber
5.15.3. Removal and adsorber installation
5.16. System рециркуляции the fulfilled gases
6. Transmission
7. A running gear
8. A steering
9. Brake system
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 



cf8e4909





5-15-2-snyatie-ustanovka-i-proverka-klapana-produvki-adsorbera.html

5.15.2. Removal, installation and check of the valve of a purge of an adsorber

The screw-driver with a flat edge is required to you.
1. Disconnect a wire from the plug "minus" of the storage battery.
2. Having pressed a plastic clamp, disconnect pad a plait of wires from the valve of a purge of an adsorber.
3. Disconnect taking away and bringing hoses from valve unions.
4. Wring out a screw-driver a spring clamp of the valve …
5. … also remove the valve from an arm.

THE NOTE
So the electromagnetic valve of a purge of an adsorber removed from the car looks. Pay attention to its marks that at replacement to establish the same valve.

6. For valve check attach to the taking away union of the valve a medical syringe (it use as the pump, and to the valve it is possible to take advantage of a hose of a supply of depression as an adapter for syringe joining). Press on плунжер a syringe — in the valve pressure (it it is possible to feel on aspiration плунжера a syringe to return to a starting position) should be created.
7. Then connect to conclusions of the valve a source of a direct current pressure 12 In — the valve should open, and pressure should disappear (плунжер a syringe without resistance will move against the stop). Otherwise replace the valve.
8. Establish the valve of a purge of an adsorber in an order, the return to removal.

The previous page
5.15.1. Features of the device
The following page
5.15.3. Removal and adsorber installation