Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
3.1. The engine is not got
3.1.1. The general receptions of start-up of the engine
3.1.2. Malfunctions in start-up system
3.1.3. Check of system of ignition
3.1.4. Check of the power supply system of the engine
3.2. Malfunctions of system of injection of fuel
3.3. Idling was gone
3.4. Faults in engine work
3.5. Diagnostics of a condition of the engine on appearance of spark plugs
3.6. The car moves jerky
3.7. The car is badly dispersed
3.8. The engine has decayed during movement
3.9. Pressure of oil has fallen
3.10. An engine overheat
3.11. The storage battery is not recharged
3.12. Start-up of the engine from external sources of a current
3.13. Malfunctions of an electric equipment
3.14. There were extraneous knocks
3.15. Problems with brakes
3.16. A wheel puncture
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
9. Brake system
10. An electric equipment
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 



cf8e4909





3-1-3-proverka-sistemy-zazhiganiya.html

3.1.3. Check of system of ignition

THE PREVENTION
On your car the microprocessor system of ignition (МПСЗ) high energy is established. Pressure is brought to high-voltage wires approximately 40 000 In and though at a small current strength it is harmless for a life, possible blow by a current at check of system of ignition can lead to serious consequences. Therefore, if you undertake a high-voltage wire at the included ignition, take advantage of a thick rubber glove or as a last resort пассатижами with the isolated handles.

    
GOOD ADVICE
Before check of system of ignition establish the gear change lever in neutral position and leave included a lay brake.

1. At the switched off ignition check up an integrity and landing of high-voltage wires in nests of the coil of ignition.
2. Check up serviceability of the coil of ignition (Check of the coil of ignition see).
3. If the low-voltage chain of the coil of ignition is serviceable, check up spark presence on spark plugs. Remove a high-voltage wire from any spark plug. Insert into a wire tip a spare spark plug and press its metal part to "weight" of the car (for example, to an inlet pipe). Ask the assistant to turn a starter a cranked shaft of the engine.

    
PREVENTIONS
Reliable contact of the case of a candle to "weight" is obligatory, as at occurrence of an additional spark interval, большего, than a backlash between candle electrodes, damage of the block of a control system by the engine or a high-voltage chain of the coil of ignition is possible.
The specified check spend no more than five seconds not to damage neutralizer of the fulfilled gases at hit in it of the engine which has not burnt down in cylinders of gasoline.

4. If the spark is not present, replace high-voltage wires new. It is possible preliminary to try to establish not new, but checked up, from the working car.
5. If after replacement of wires the spark has not appeared, replace the ignition coil (Removal and installation of the coil of ignition see). If the spark is, but the engine is not got, replace spark plugs new. It is possible preliminary also to try to establish not new, but checked up, from the working car.
6. If and after that the engine is not got, check up serviceability of a control system of the engine (Malfunctions of system of injection of fuel see).

The previous page
3.1.2. Malfunctions in start-up system
The following page
3.1.4. Check of the power supply system of the engine