Chevrolet Lanos (since 2004 of release)
1. The car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance service
5. The engine
6. Transmission
7. A running gear
8. A steering
9. Brake system
10. An electric equipment
10.1. Features of a design
10.2. Assembly blocks
10.3. The storage battery
10.4. The generator
10.5. A starter
10.6. The switch (lock) of ignition
10.7. A control system of the engine
10.7.1. Features of a design
10.7.2. Possible malfunctions of a control system of the engine, their reasons and ways of elimination
10.7.3. Check of the coil of ignition
10.7.4. Removal and installation of the coil of ignition
10.7.5. Removal and installation of the electronic block of engine management
10.7.6. Check and replacement of gauges of a control system with the engine
10.8. Illumination, the light and sound alarm system
10.9. Replacement of a motor-reducer of a screen wiper of a wind window
10.10. Removal and installation of a washer of glass of a wind window
10.11. Removal and installation of the electric motor of the basic fan of a radiator of system of cooling of the engine
10.12. Removal and installation of the electric motor of the additional fan of a radiator of system of cooling of the engine
10.13. Electroheating of glass of a window of a back
10.14. Removal and cartridge installation cigarette Lighter
10.15. A combination of devices
10.16. Switches of the panel of devices
10.17. Replacement of blocks of management эpower windows
10.18. An automobile audiosystem
10.19. Replacement of gauges and switches
11. A body
12. Wheels and tyres
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Councils to the beginning mechanic
18. Appendices
19. Electric equipment schemes
 



cf8e4909





10-7-3-proverka-katushki-zazhiganiya.html

10.7.3. Check of the coil of ignition

The tester or ohmmeter is required to you.
1. Disconnect from conclusions of "1" and 4 coils of ignition high-voltage wires …
2. … also measure resistance of a secondary winding, having connected an ohmmeter to conclusions. Resistance should make 5,0–6,0 clod.
3. Repeat check for conclusions 2 and 3.
4. If resistance at least one of secondary windings differs from specified, replace the ignition coil (Removal and installation of the coil of ignition see).
5. Connect into place high-voltage wires.

THE NOTE
Before installation grease tips of high-voltage wires консистентной with greasing, for example technical vaseline.
The previous page
10.7.2. Possible malfunctions of a control system of the engine, their reasons and ways of elimination		 The following page
10.7.4. Removal and installation of the coil of ignition